what do you mean exactly.
is at parameter 1815 X axis bit 4 and 5 set to 1? or are both 0?
if both are 0 you need to do it with gridshift (parameter 1850)
Type: Posts; User: khaot183
what do you mean exactly.
is at parameter 1815 X axis bit 4 and 5 set to 1? or are both 0?
if both are 0 you need to do it with gridshift (parameter 1850)
Hi,
did you install the option afterwards? if not please check if there is a wire in Y5.0 at the i/o boards. if yes you have it
do you know how to read the PMC? then i could tell you some...
Micki,
you can turn it manually.
so did you do the procedure k5.0 ->1
spindle stop+spindle select+feed hold button to unclamp the turret rotate it so position 1 then CALL BZ button
after...
Check your input Power if all 3Phases have the correct voltage and check the fuses which are befor the Amplifier. seems one Phase is missing. Maybe one of the Circuitbreakers after transformer or the...
Ok but what Hyundai-kia machine model is a K 5....
and which controler does it has
I think it is because of the Gearbox.(Parameter)
as Low gear is from 0-550 rpm (i thought 500rpm) and you are during cuttingcycle it will not switch to second gear which is from 550-3000RPM
and...
did you check the relais?
Hallo,
try it with
M73 : HYD. REST CLAMP
M74 : HYD. REST UNCLAMP
M77 : HYD. REST PIN IN
M78 : HYD. REST PIN OUT
if this is not correct give me a feedback and i will check it as this is...
But i guess you will also need to replace the bevel gear and quadrings. as Lyfordln will supply you the drawing you will see how to disassemble it.
also you can remove the black plate, where the...
SET the PC PARAMETER (D DATA)
D9.5 Auto Mode x axis interlock
D7.5 Jog modus x axis interlock
D12.4 B axis interlock
after that it should be pssibe to rotate in jog and auto mode in any...
i don´t have any PMC of this machine but this is PC Parameter protected...i gess.
as when you want to check it by yourself, you should try 25%/50% and 100% override
it will be the same speed....
did it work?
i would reccomend you to disable the Y axis software limit switch
1320 Coordinate value I of stored stroke check 1 in the positive direction on each axis
1321 Coordinate value I...
Please check, when this trouble occure once more time, the F1.0 signal insite the PMC / Ladder diagram (this is Fanuc alarm). if this is on there is some alarm at your NC after that you can try to...