Yes they are still calling it J1 (with subtitle V1-VR) as you can see here in a closeup picture attached
430356
Type: Posts; User: JackMath
Yes they are still calling it J1 (with subtitle V1-VR) as you can see here in a closeup picture attached
430356
no pdf but manual page as per photo attached regarding V1-VR jumper wich appears to be the same as jumper J1
In my case, I left the jumper as shipped by the factory, position 2 and 3 and it work...
no pdf but manual page as per photo attached regarding V1-VR jumper wich appears to be the same as jumper J1
In my case, I left the jumper as shipped by the factory, position 2 and 3 and it work...
Thank you Mactec54
I often hear about jumper j1 but I have not yet spotted it, could it be that in my case it is the jumper V1 / VR as in the photo attached ?
Jack
430308
Hi
Problem Fixed
Here is the change I've made in my parameters:
PD002 was change from 0 to 1
Hi
I have a Huanyang VFD HY01D511B 110V 1.5kw, and when I turn it on, the potentiometer display turns on as usual and when I press the run key,
the spindle start until it reach the maximum...
Hello
I just finished an aluminium extrusion CNC mill project, which I'm currently using with a router Boch colt 1.0 hp.
Now, I want to limit the noise first, and increase the power of the...
Hello
I just finished an aluminium extrusion CNC mill project, which I'm currently using with a router Boch colt 1.0 hp.
Now, I want to limit the noise first, and increase the power of the...
Thank you for your answer,
I don't think they have local distributors close to me in Quebec and I don't think they have an online shopping service.
Is there an other way to manage without...
Hi
I am currently building a cnc
I have on hand my lead screws "Nook Acme screws 1/2-5 10tpi " .
I need help to find the proper end bearing support and anti-backlash nut housing designed for...
Thank you for your reply,
If you have suggestions for cheaper versions it would be appreciated.
Jack
Hi
A bit not familiar with that type of replacement.
I have 4 nema motors Keling KL23H276-28-4B and I work with Mach3 software.
My Rockcliff stepper driver card 4X discontinued (PN...
Sorry, I have a multimeter but I'm not sure how to perform this check, can anyone help me?
Thank you
Thanks
Hi
All 4 stepper motors stop suddenly working under Mach 3 on my main pc and even with my 2nd pc.
When I hit the x, y, z buttons on my pc Mach 3 is moving on the screen but the step motors are...