I've been using the BSMCEO4-PP USB Controller board the RnR Plugin and Mach3 to control a converted Seig X3 mill with no problems.
I also have a Boxford Orac lathe running Mach3 through a parallel...
Type: Posts; User: tiffyted
I've been using the BSMCEO4-PP USB Controller board the RnR Plugin and Mach3 to control a converted Seig X3 mill with no problems.
I also have a Boxford Orac lathe running Mach3 through a parallel...
I have beeen running one of these machines for about a year now. The other day the spindle refused to run. Checked the motor by bypassing the controller and the motor is fine. I checked the board...
I have had a similar problem recently. Board was working fine, but after updating my Pc it would not work at all. motors just sat there and hummed. I also noticed the LED's indicating which motor...
Hi to all,
I have a professionaly built 5 Axis controller supplied by Heiz using the TA8435 controller chips and that is rated at 32v 8A, and supplied with a machine fitted with 2.5A motors.
...
Hi your board is likely the same as mine which has the following connections to the DB9
DB9
pin 1 connects to PP port pin 10 active low when grounded
pin 2 connects to PP port pin 11 active low...
I purchased one of these boards from ebay recently. After much head scratching and cursing I now have it working under PC control with Mach3 via the DB25 copnnector and under manual control via the...
I think you may need to change the port setting. I had a similar problem caused by the port being set for ECP when changed to EPP all the motors worked. I think, though not sure, that the problem is...
The motors can be connected in a couple of different ways, but easiest would be as follows
A+ Blue, A- Red. B+Yelow B-Red Insulate the 2 black common wires.
You can connect for parallel, but...
Hello to everyone.
I'm new to this forum, so a few words about myself.
I'm a retired scientific instrument maker, previously involved with many different instuments for the space and industrial...