Search:

Look at OneCNCXR2
Cheaper than Mastercam and much easier to use in my opinion and beleive me I needed the easy use software.
Also look into the ethernet/USB connection for your TM if money is no...

I bought my TM1 and TL2 in January of 2004.
I initially set them both up in metric mode only to find that the Haas software at the time was not working properly in Metric. You can imagine how many...

I recently purchased OneCNCXR2. I think the product is good for the money. It is much easier to use than Mastercam. The manual seemed a little disorganized to me especially being a Newbie to CNC. ...

This may not be your problem but I thought it might be helpful anyways.

I would first recommend that you make sure you have the most current software available because I found out as a new owner...

This information is a little out dated. It shouldn't even be on this forum.



Does anyone have any current comparisons of the two programs ? (Oct. 2005)
Personally I have tried Mastercam V9...