Is anyone running a tormach mill with pathpilot controller and using onecnc,
Im looking for a post processor.
Thanks
Type: Posts; User: motomitch1
Is anyone running a tormach mill with pathpilot controller and using onecnc,
Im looking for a post processor.
Thanks
free tip
Promises are not binding (Get It in Writing)
I recommend that the customer takes careful notes, then send a certified letter to the company outlining the terms of the verbal...
There is some weeds even in the USA
onecnc will inport parasolid files and solidworks files
How low will the RPM on a vmx 24 with the 12,000rpm spinde go down to ?
Yes tricky I now know what you mean
It's not worth the effort to dress a sparrow up in peackock's plumage. If you want a peacock, start with one.
You could fix the pc with a PCI parallel port add in card
A CB shop I use to go to used finger nail paint on the screws and it would chip off if you took the screws out:eek:
sounds like a good deal to me it could go for $4000 to $8000 on e bay
kevin,
They have some more videos on a FTP sever at onecnc.com that you can log on to and download.
http://www.3sincorporated.com/co_info.htm
You can also use (Surface from Curves) and it only takes 1 mouse click.
If you swich over to three Gecko's you wiill have a controller that will actually run 100% of the time. :D
They all cost more then Onecnc.
Do you mean like the barracuda?
http://www.cnczone.com/forums/showthread.php?t=5026&highlight=barracuda
Disk brakes work better than drum brakes,and when you stop most of the weight is transfered to the front of the car giving the front of the car more traction and stopping power.
If you have 13 to 40 and then 40 back down to 13 then you would have 1 to 1
Mach 3
Is it a Dynapath 20 controller?
Is the controller set in the rs232c mode?
I gave up because I thought it was a option that i didn't have, them wizzards look pretty handy.
Thanks Gerry
That was it:D
Hi pminmo,
I haven't figured out the mach3 wizards, when I type in a number it changes back to some default number. I switched from Qstep to mach 3 and haven't used mach enough to know how it all...
G00g90x-0.162y-0.038
G00g90z0.
G01z0.f100.
G01g91z-0.
G01g91x0.112
G01g91x10.05f100.
Y0.104
X-10.05
Y0.104
G01g91x10.05f100.
Thats a really nice low budget torch table.
.
I had the Harbor Freight mill and made it cnc it worked pretty good it could have used a little more rpm, you need to take the drill chuck out and put a R8 collet in there for milling...
1 Real Bridgeport will do the same thing when you adjust the knee, you aways should crank in down pass where you want to go and then crank it back up.
2 thats normal if you cut down the center of...
Turbo Spindle & hand grinders have been around for years so it will work.
http://www.emazing.com.au/tools/airturbine.htm