Hey,
Thank you very much for the reply. I feel like the ultimate noob here. So my apologies above all.
i am also upset with myself that I didnt look up before if these were left hand or now....
Type: Posts; User: victorgallas
Hey,
Thank you very much for the reply. I feel like the ultimate noob here. So my apologies above all.
i am also upset with myself that I didnt look up before if these were left hand or now....
Hi,
We recently acquired an ACRA Mill that uses essentially a bridgeport clone head.
While getting the machine up and running I noticed that the quill does not go up all the way smoothly. About...
thanks for the reply.
I actually did contact EMI and got what i needed from them for the machine,
Just need to spend time to get it all setup and running here.
But most of my problems with...
So I was able to get the machine to home and work correctly. Turns out that I think I had a bad wire, or corroded connector from one of the encoders back to the aux BOB board. Reset it and now it...
So I was able to get the machine to home and work correctly. Turns out that I think I had a bad wire, or corroded connector from one of the encoders back to the aux BOB board. Reset it and now it...
Since I am asking for help on this forum, I wanted to give back by providing some of the documentation we have on this machine to those who need it.
I am still in the need for the disks to...
We recently acquired an EZ PATH Bridgeport lathe. When we received the machine it had some issues to be addressed. One of which was that the PC was not able to see the BMDC board. After several...
We recently acquired an EZ PATH Bridgeport lathe. When we received the machine it had some issues to be addressed. One of which was that the PC was not able to see the BMDC board. After several...