Yes, all that were there are the same.
Type: Posts; User: THREEPT82
Yes, all that were there are the same.
.
The repair guy will not be here until the 10th
" No, the remote would have to be attached and the feed rate turned off for that to be the problem. "
Burst my bubble with your own idea...
I program using a Fanuc base because Haas and Yasnac are all based on Fanac but for a
few extra codes they added. G12, G13 and so on but the Fanuc code is understood on all
of them.
I dont use a...
Has nothing to do with comp.
Will not do canned cycles, milling or anything that requires a feed other than rapid.
Tried MDI abs. and inc. with and without decimal points.
Runs thru the graphics...
I was just on the phone with a tech from Haas.
He gave me a few things to try which I will tomorrow but he didn't feel they will help.
I'm just trying avoid a service charge but if I need to, I...
On line has only new updates.
Im looking for an original 1998 machine/operator manual.
I downloaded the Haas site manual.
It was informative but most didn't pertain to my machine.
Does anyone out there have a PDF of an operators manual for a VF-E Mill?
I could not find a Inverse Time Feedrate setting anywhere.
All is in inch and no movement at all.
Inverse Time Feedrate turned off? I will check that.
Should it be on or off?
That is a section of the program.
Correct.
It stops at " G1 Z-.1212 F22." but the screen says its running.
I took this program from one smaller Hass that runs great to this machine as a good job to start with and thats what I get.
%
O0056
(DATE 01 / 03 / 13 )
(HAAS)
()
G54
G0 G17 G40 G49 G80 G98 G90 G54
T1 M6 ( 1 INCH INSERT MILL - APKT-1003-PDSR LT-1475 )
( RUFF O.D. )
S1950
there is.
Any other ideas out there in cnczone land?
Please bare with my. This is my 1st thread
We just brought in a used Haas Model VF-E.
Set it up, Leveled it up.
Made a warm up program with all rapids and G90 / G91 moves.
All works great....
No. Just that silly CamConnection.
Hi Guys.
This is my first time on your forum. I've used Smartcam about a hundred years ago. The place I'm at now has Ver9.1 3d mill and lathe. They also have Mastercam 3d mill/solids and lathe. I...