Search:

Does anyone have experience or knowledge in using the new Centroid Acorn vs. 4 control board, 4 axis, for use on a plasma table? If so, how is the THC configured?? I recently purchased the Acord...

Does anyone have a way to contact Neuron CNC? Their site does not have a direct access phone number, or their location for that matter. My only reservation in using one of their systems at this...

Does anyone have experience in purchasing and installing CNC controllers offered on eBay by manufacturers in China? They offer 2 & 3 axis controllers in very compact sizes, with 10" built-in LCD...

Any progress in retrofitting your table? I own a Tracker 4' x 8' table, built in 2005. The THC is dead, and no longer supported by tracker. I am also in the same boat: looking to upgrade my table'...

Not sure this was meant for my quest, but rather for a cmc mill or lathe???

Thanks for taking the time in replying to my post Countryguy. What takes place with my plunge control, when enabled, is that it when I start a cut, I will bring the torch to the plate, slightly above...

Looking for some help with my CNC plasma table.

I recently purchased a used 4' x 8' plasma table manufactured by Tracker. My plunge control will not function properly. The service from Tracker has...

Anyone have any feedback??? Nothing as of yet!

So what do we know about CNC Mogul? Anyone have experience with their equipment? Also, where are they located? I would like to see a machine before I commit to buy!