Hi Anthony, on a FA450 with a M530MH control. The control was not coming up, we got all that squared away, but when we press the F0 button and press the function switch none of the switches come...
Type: Posts; User: cruiser1821
Hi Anthony, on a FA450 with a M530MH control. The control was not coming up, we got all that squared away, but when we press the F0 button and press the function switch none of the switches come...
You should check the drives typically you will see a 58 on the NC but a 55 on one of your drives. Once you find the the drive showing a 55, check your B and R terminals, if there is a jumper between...
you should go to the diagntosis page, then press the version soft key, then press the option soft key. This list all of the options for your control.
CM2 files are generated by a software that mazak has (i think its called MDTwin) that acts like a cmt box, but instead you can save onto a computer. you are going to need someone with the that...
I1 sets the baud rate, but you also have to take a look at parameter I65 which sets the correct port for CMT. Its a 7 bit parameter and you set it by the following:
Bit 0 - CNS31 - MC712
Bit 1 -...
if you are getting this alarm, it probably means you are getting some type of alarm on one of your drives. the most common one for this is a 17 on the Spindle drive. sine this a 32 controller (not...
this one seemed like an odd problem and was just curious if you could give us an update just in case someone else has the same problem in the future. i think reinitializing is a good idea, but...
Try taking a look at parameter K11 it is probably set to 2 which is German if you set it to 0 that should put it back in English
Well you could check the PD21 voltages which is the NC power supply. It is located in the electrical cabinet. it is located in the control rack on your right side. it also has test pins that you...
128 is usually just a general E-stop. you might want to check what your axis drives are displaying, also your spindle drive one of them could be generating the alarm. i would only recommend...
On the 640 control this is an option so not all controls have it. You could find the control mounted right behind your screen, you can open up the back of the control and the PCMIA port should be on...