MrMazak i will give it a try here in a few hours !!
Thanks again!!
Type: Posts; User: rwpbrian
MrMazak i will give it a try here in a few hours !!
Thanks again!!
If I do that the drill isnt going to rapid through the part to at Z4.35?
The drill will go above Z0 then go down to 4.35 and start drilling?
Hello
I'm programming a Mazak Integrex I 200 st with a Matrix 2 controller using the Mazatrol programming
The programming question I have is
I have drilled a .34 diameter hole with the milling...
Hello
I program a mazak integrex I 200st and was wondering if anyone has done any EIA/g-code programming using
balance cutting or 2pc programming. I have used both options in mazatrol with good...
thanks everyone for the info we start to put these parts into production late next week. I'm going to set the program up Monday morning!
Hello
I was wondering if any one had any ideas for me
Programming a Hardinge T-42 with a Fanuc 18-T controller.
Working on a job where we are using a large diameter material thats too big to...
Just thought i would post the fix
Had an tech come to look at it and right away checked the mother board and found it had become a little lose, pushed it up and into place and the lathe is now...
I know this is an old thread but did you ever come across the fix?
I am having the same problem on my Bridgeport/Romi ezpath lathe.
I get the GP fault - fatal error which is followed by a ...
Hello
I was wondering if anyone could give me a hand programming with this live tool.
The machine I am running is a Hardinge T42 with a Fanuc 18T controller.
I have been programming CNC for about...
Thanks Bill works great!
Also I was wondering if you had any knowledge of programming live tooling with the Fanuc 18t maybe i can run a couple things past you if you dont mind?
Thanks Brian
I was wondering if someone could give me some info on how to thread an internal thread on my Hardinge T42 with Funuc 18t
Heres how I would thread an O.D.thread
(THREADING 25mm X 1.5p...
Hey Manz
I was wondering if you ever found a mastercamx4 post for your bp romi lathe?
I know this thread is a bit old but did you have any luck learning this machine??
I have been running one for some time now and have become pretty good at it
any questions let me know
Brian
Wow thanks for all the info guys!
I'll give it a try tomorrow and let you know how it turns out
Thanks again
Brian!
Hello
I started a new job running a Hardinge T42 lathe/turning center. A lot of the parts i have been doing have o-ring grooves machined in the parts O.D. The guy running the machine before me has...
Wilmet
I have been running one of these BRIDGEPORT-ROMI-EZ-PATH lathes for about 5 years now, really easy to program only problem we have had with this machine is we have put on a 4 jaw chuck and...