Search:

Hi all.

I have two issues with Xilog Writer Cad from SCM.

-----------------------------------------------------
The History:
-----------------------------------------------------
Despite my...

Just as a matter of interest - what type of algaecide should I be looking for here?

It's something I'm going to have to consider as my workroom has been reaching around 35-40deg c while I am not...

Yes I used white insulation tape and lowest power to do the allignment.

I'm aware of the risks of polycarbonate.

I do my homework. I have a correctly fitted respirator mask for this purpose, as...

Well I have plans to make a small pic controlled relay board, and automate everything, so I'll write in a pump delay into the program.

So it will remain running for 5 or 10min after last use and...

From the few test runs I am running at the moment, all appears quite well.

This may not be the case when I find myself a set of digital verniers.

For now I am in the learning stage.

I will...

The pump and stuff arrived today.

It took me a little bit of fiddling to find out what my real issues was.

The laser path had been disrupted by both a bubble and also the damage to the head...

Sounds alot like what I had planned to put together myself.

This may save me many hours on Electroncis Workbench.

Just got word from my home base that the pump, software and other bits have...

Well this particular model has an analog current control.

adjusting this and depressing the test button causes the current meter to jump up.

The current displayed appears to vary with...

Yes I had read that my options may be limited, but I purchased after researching my upgrade options.

I'll decide on what to do after I have had some time to experiment and learn.

My main...

As far as anti-microbials go - what would you reccomend?
I notice that many are chlorine based, and off memory, that can be rather destructive to most metals.

I have observed that the water does...

The pump has not yet arrived, However I have a smaller equivalent that I am using simply to ensure that water will flow correctly.

I managed to remove all but one bubble with the pulsing method as...

Good News, it has finally arrived.

The tube appears to be intact, so still good.

The transport carriage had a couple of broken runners, but nothing that a lathe and some patience cannot fix.
...

I have read this in other posts and texts that I have dragged up in the course of my research before purchasing this machine.

It appears to be sound advice.

As I am currently employed as a CAD...

I think for the time being, I'll stick to distilled water with some algacide until I am a little more confident with the machine, as the manufacturer calls for distilled water only.

Knowing my...

Hello all,

I'm a newbie to the forum and to glass laser tubes, but not to CNC machines.

I have had a long read of many threads but have not found definitive answers.

I have just purchased,...