Search:

Hi Tom,

the PWM1KHz.c example worked. Also the "SpindleMach3PWM.c" works fine. I'm able to control the PWM -> voltage output from Mach3. However now it is an open loop. How do I get the encoder...

Hi,

thanks for your feedback. this are the results after testing this weekend:

a) The spindle has a encoder for feedback. Feedback is connect to kflop. I'm able to read the feedback, but I have...

Hi Tom,

thanks for your feedback. Other things needed my time. However last weekend I changde the program and it worked.

Regards,

Mark

Hi Tom,

Followed your instructions. It is working perfect. However is working always, hence even if mach3 is stopped / running a program disable the MPG. Because now the machine always reacts when...

Tom,

Without you understanding the question, the provide answer is very clear for me. nice job !

regards,

Mark

Hi Tom,

Thanks for your quick response. I will give it a try this weekend.

Small question: the c-program for the MPG is that combined with the "standard" c. program that contains the axis...

For re-fit project we are using a Kflop in combination with Arduino Modbus and Mach3. The simple setup is working fine. However there are some challenges.

The lathe needs to have a MPG pendant....

Hi AI,

Indeed 0V is 0 rpm -10V is full rpm revers. Also I think that the mention outputs are provide. I will check this weekend.

Tom,

The encoder is quadrature dualended. Hence I will make...

For a upgrade project of Mori Seiki Lathe I'm using Kflop + Mach 3.

The Kfop works with Mach3 and both X and Y axis. The axis are driven by existing motors, with new servo drive that accepts...

Hi,


I trying to retrofit a old Maho 600 with Kflop / Kanalog and Mach3. The old controller uses a linear encoder (sin /cos) as input. Can I use the 8 ADC on the Kanalog as input for the axis.
...

Hi

I'm Mark from the Netherlands. Busy with retrofit of Mori lathe. Planning to install Mach3 with Kmotion and Kanlog board. For this project I'm looking for the manual / connection diagram of...