I might be able to supply a board from my KM3P retrofit. I am in Colorado, USA.
Type: Posts; User: sitzme
I might be able to supply a board from my KM3P retrofit. I am in Colorado, USA.
I had a similar problem with a KM3 and added a time delay between brake off and spindle start. I also had to disassemble the brake cylinder and clean/reseal it. There was an amazing amount of crude...
KM3 uses a similar looking oiler. One shot at a time about every 15 min under program control in my case. Some new ones have timers as I recall. There are assorted discussions on the net regarding...
I will have to go to storage and check it out.
I might be able to help. I did a conversion on a KMP3 and the machine was said to be working but I didn't power it up before pulling everything out that was not needed. There are also some...
Not sure but I think it is Amphenol 206044-1 cable end, Amp 206043-1 bulkhead. For future reference.
I got them and these numbers are good. If you do the search and poke around a little, you...
Not sure but I think it is Amphenol 206044-1 cable end, Amp 206043-1 bulkhead. For future reference.
I am working on a KM3P and the Z axis cable plug is damaged. Does anyone know what the brand/part number is for this plug? It is the end that plugs into the cabinet. I can cripple by for a while...
You should be able to find boards on eBay. I will be selling the controls out of a KM3P in a while also. I also bought a pair of KM3's and the shipping company destroyed the panel on one and a...
The ad is gone. Maybe post photos here?
If it turns out to be the crt I have left overs from a retrofit. Good luck with your debugging. Hopefully someone will chime in.
I am not an electrical guy by trade but have been around industrial machines a lot and pickuped some knowledge there.
I am in the process of a KM3 retrofit also. Mine is to the point where I can...
Thanks. I can pop the covers and check the belt condition. Is the gear selector lever adjustment easy to figure out? Do you have any idea if Clausing/Kondia wants a minor fortune for the splined...
I am in the process of resurrecting a KM3 and when I powered up the spindle it seems noisy. My first thought is motor bearings which I can replace easy enough. I have never been around a KM3 when...
Does anyone have a current (2019) source for KM3 or KM3P manuals?
Well I didn't hear anything in time and it turns out that the control panel can be removed DURING SHIPPING! I guess an unplanned control retrofit is in my future.
I bought a KM3P and with the control arm on it is 96" front to back. Can KM3P operator panel be easily removed for shipping? It looks like it would shorten it by a couple of feet. Possible? How...