Search:

Hello Sir,

could you inform, how to input diagnostic?

hello,

Could you inform how to input manually diagnostic 300 to 499 please

Problem solve

Need to set up parameter M13 bit 5:wave:

CNCmakers001

do you know which parameter on mazak 640M controller to setting up it..?

Dear Friend,

I face problem Z axis direction on Mazak machine 640M controler
Z coordinate on monitor side is correct with command but actual direction is reverse

For example

If move Z up......

Hello Sir,

Could you help to open password ladder Fanuc of my machine..?

Could you inform..what parameter need to change..?

Hello friend,

does anyone have backup windows for mazak QTN matrix controller..?
our machine have problem on hardisk

if anyone have that backup windows, please share it

Thanks for your...

Please check PLG spindle, possibility PLG spindle spoiled

anyone know parameter for setting loop gain and frequency of spindle motor machine Mazak QT Smart controller..?

Hello All,

Does anyone know how to setting home set turret Mazak QT6T Mitsubishi Meldas 64 controller..?
battery turret was weak and machine alarm battery

Could you share electric wiring diagram of robodrill machine please..?

After replace PCB HN765, please do SRAM Clear and restore all back up data
it will be syncronizing PCB and NC unit

Machine is incremental encoder

Limit switch was check all normal

now Z and X axis can't move backward

Press P+Can and reboot the machine
unfortunately machine still problem, can't move back ward

any other advise..?

thanks for your attention

Thanks for your suggestion,
by the way press P and Can during reboot not effect in memory NC..?
I just worry, if press P+Can+ NC on..it will be erased memory NC

Thanks for your attention

Our CNC turning machine got problem on axis Z
machine no alarm, but axis Z can't move backward ( + ) direction even in manual or auto mode
machine only can move on forward ( - ) direction only

I...

Please go to TPC data and set TC parameter < especially TC 38 >

Dear Darek,

Please contact your mazak distributor to know WPC shift on VRX
and you can request WPC shift on HCN -4 axis to them

Basically workpiece coordinate system is G54 - G59
But on Mazak < turning or integrex machine > you're setting workpiece coordinate system is available on G54 - G55 and G53.5 < mazatrol coordinate...

You need to set IP address, you can request to Mazak TG to help you if any confused
do you have private emaill..?
i will send it to you

You need to turret home set

Did you check spindle alignment 1st spindle and 2nd spindle..?

Please make a main program and top cut program as follow

Main program
exp. program number 10
G28 U0W0
G0 X..Z...( stopper position )
M6 ( chuck open )
.... ( bar feeder push material )
M7 (...

Dear CPFef

As i know, syncronous tapping is OPTION
please check your option list

Friends..
G32 is for threading...
not for tapping
You must use G84 or G88 for tapping
Format for tapping similiar with drilling
T0404
G97 S350 M3
G0 Z20. X0.
Z2. M8
G84 R1.

Dear Woody

Where you put program..?
Memory, hard disk, or ather..??
Please check, no of program on memory max 256

hello tward74

That alarm means, your program is wrong for end of Z position
Please check your program..

Dear Alexcomo

Don't worry about programming for mazak machine
mazak have conversational programming and it's very easy and friendly
Mazak application engineer will be support you when you buy...

Do you have emaill?
i will send procedure how to calibrate probe on VCN
Thnaks