Thank you for the help. I just had the same exact problem. I plugged J10 in one row or pins low. It’s a little hard to see in there so close to the floor. Thanks again for saving me.
Type: Posts; User: Terrible Terry
Thank you for the help. I just had the same exact problem. I plugged J10 in one row or pins low. It’s a little hard to see in there so close to the floor. Thanks again for saving me.
I have resolved my programing problem. I got brave and entered a few commands and the first tool loads and lifts extra high before part locates and part moves 10 inches to the right before tool...
Hey Im looking for someone near Coos Bay, Oregon that could meet me and help me edit some G code. Im using Fadal Format 1, G code produced in Mastercam X4 and Edited in Cimco V5. Only drilling and...
Thank you for response and will check into that after I get past my problem. While I was installing drawbar, new spring washers etc. I discovered that the new shaft from the air cylinder that pushes...
I had a drawbar problem at some point and did not notice it at the time it happened, the shaft of the air cylinder that pushes down to release the drawbar was mushroomed out and blue and purple from...
I was machining some oval shaped pieces and noticed the axis movements are jerky and create little straight lines, like the machine is stopping for a moment at each direction change. The stepping...
Thank you for any help right at the start of this my first time. I have been using my Fadal 4020 for a year or so and decided to add a 4th and 5th axis. In the installation I apparently miss landed 4...
Newbie here and only have had a Fadal 4020 for 3-4 months. I only have single phase power and I have been running my vmc on a rotary phase converter with no apparent problems. The belts started...
Hey Im new to posting but here goes. Had a similar problem with my 4020 and after resealing around casting leak was stopped. I used Ultra Black RTV and it seams to holdup.
The existing caulk look...