Search:

Yes. All cables are shielded as well with the shield wire open at the switch end and connected back to the star point ground in the panel.

So I have my DIY CNC running with a G540. I installed limit switches and immediately started getting false triggers. I wired and grounded everything to best practice standards but the 1617 Router...

Thank you for this. I will go update asap. I had some success last night. If I remove the Z-axis limit switch entirely then I dont get any false triggers. Hopefully the debounce setting will help...

Anytime someone asks me about building a CNC machine I tell them absolutely do not. Buy a kit that already has the bugs worked out and a support system in place to troubleshoot. Learn from my...

okay. if it is noise how do i eliminate it? i have shielded wire and grounded my steppers. This problem came about once I installed Home switches. I installed shielded wire for the switches and...

I built my own machine. Its approximately 36"x44" 1/2-10 single start lead screw driven. UCCNC. UC100. G540 controller with Nema23 389oz/in 3.5A stepper motors and 48V 7.3A power supply. Gantry is...

Yes I am running it in inchs. I have tried to run this machine faster but once I go past 70-80ipm then the motors will stall and I will lose steps. I had that issue with my Z-axis when it would try...

Sorry, they are 1/2" - 10 screws. I believe velocity has been set down to around 30units/min with acceleration around 10units/min. This is for X and A and it has given be the best results. Y axis...

I just finished up my extruded aluminum style CNC router. A little background on this machine that I designed:

V bearing guides with Fixed and Eccentric bushings.
1/2"-10 Acme rods (48" Y,...