Still in the same boat.
Type: Posts; User: Grift
Still in the same boat.
I put it here because it still involves all the equipment in the thread
Sorry if this is a thread Hijack, But with over 100 pages, there's a lot in this thread to dig through. My old computer died and I had to upgrade (windows 8) no parallel port and I'm having an issue...
I'm sorry if there is a thread already floating around.
I recently had to switch my CNC computer and had to go with a smooth stepper. It's working fine but I got to thinking about some of my old...
As an update I followed the testing steps shown in this video, and found that it was a physical issue. one of the mosfets on the G250 driver board for X had shorted out. Since I have an older unit...
Well, further testing with the monitor app for stepper has me thinking I may need to bite the bullet and get a new G540 or see if I can get it repaired. I tried creating a new profile and that still...
Yes I'm using a Gecko G540 as the BOB. The only new thing was the ESS and I'm still trying to figure out if there is a page to define the pins out from the ESS to the router itself.
I have an issue. The computer controlling my router died. It was old and had a parallel port. The new one does not have a port and running windows 8 64 bit I had to get a smooth stepper. After...
Sounds like the veneer is being affected by the heat from the laser.
You could test your duration of the laser exposure, treat it more like a router taking small cuts rather than a laser scroll...
Have you thought of making a sandwich? Solid wood, plywood or fiber board above and below the laminate and then cut it?
I'm pretty sure when you're vectorizing an image it's outlining the complete line. I would try a pocket or vcarve inside the vector. End results will be one line the approximate thickness of the...