I"m curious are you feeding straight in or are you leading the tool with a 29.5 or 30 deg. lead, this will help from loading and pulling the tool in which tears the threads. You might also try...
Type: Posts; User: minardsanders
I"m curious are you feeding straight in or are you leading the tool with a 29.5 or 30 deg. lead, this will help from loading and pulling the tool in which tears the threads. You might also try...
In response to the threading question. The dia. you have given is not a american thrd. Allways remember that you can cut any thrd on any dia. ther are alot of metric thrds. out there today that are...
I don't know alot of anything about these post processers, but aren't I&J departure command's from where you start in a arc, and X&Y where your going to, forgive me if I"m out of line. Minard
I have a old book from the henry ford trade school, formula for thrds are as such, cos. 30 deg, is .86603= thrd form. male thrds are 75 percent= .64952 female thrds are 62.5 percent .54127 take 1"...
I have noticed that we have to set the carriage close to the end of the table, three to four inches from where home is when we shut off, otherwise it will show travel stop errors not set. see if this...
Does the tailstock have jackscrews one directly across from the other, down towards the base, make sure that you don't have the tailstock locked down when you adjust as this will break the slide, it...