Search:

I hope you left out the 0 (zero) on the transformer rating. 1A aint gonna get you very far. You need 10A.

Cool, i wanna do the same for my hobbycnc enclosure. I have a full sheet of 5mm clear perspex 3m x 2m standing idle. I need to build my machine first and then use it to make the enclosure ( using a...

The thing is, with 4 axis there aint a whole herd or unused pins, esp when you wire up all the limit home and e-stop switches.

Hi there,

I have a 4 axis HobbyCNC board occupying my par port. Is there any other DIY type hardware i can add for additional control through either the serial, i2c or a usb port?

I want to be...

Making an interface that runs SPI or serial or any other protocol for that matter is reasonably simple. Most microprocessors have hardware support for it. The issue comes in with your current...

well mixing metals could be disastrous. Steel dust will eventually rust and if you happen to have aluminum powder in there aswell, then you have a potentially lethal mix. A sufficiently hot...