Search:

That looks very interesting. How is the chuck mounted inside? Tapered tailstock backplate? Couldnt find size to fit.

Hey Mike,
I just recieved a 5.2 BOB from UPNORTH. I now have this same issue and wanted to see if you had any pics or can guide me in the right direction with getting the voltage needed for spindle...

Hello, I just purchased a practically new Torus pro. I just finished up building an enclosure for it with a flood coolant system that actually works and dumps chips into a bin.
To my question, is...

Hello,
I am running the max of 6000 rpm on the Torus, cutting aluminum 6061. The grizzly is also running at 6000 rpm, with the belt drive and new motor/spindle pulleys.
Grizzly is 2-1 ratio, so...

Here is a video of it in action. This is .05 Stepover, .2 DOC and 40ipm.

https://youtube.com/shorts/2Hjo3Lwr5BQ?feature=share

Thank you for the feedback, appreciate it a lot.
Sounds like its on par with what it should be then.
The gas spring was the first thing I replaced on the machine, besides the battery for the PDB...

Hello,
I just took a video of the mill cutting with the spindle speed/load shown.
Something is going on, either with the settings or elsewhere. Usually the max RPM is 5400-5500. It will drop down...

Thank you will definitely take your advise.
I will change some of the small wiring in there that feeds the VFD to 14awg, the current looks like 18awg. If that doesnt work, then I can try the VFD. I...

I just changed to manually input on the VFD. Set at 6000rpm, I get the full 6000 rpm now. So now to check the Mach 3 input to see if I am getting the full 10vDC when I should.
You pointed it out,...

Follow up to my last reply.

Mach 3 is sending 8.3 - 9.4 volts DC to the VFD when I have commanded 6000rpm in Mach3, It definitely fluctuates. . This may be a Mach 3 or possibly a ESS smooth...

Thank you, greatly appreciate it.
Well yesterday, I unplugged everything and looked at all the terminals, triple checked all the terminals to make sure they were tight. This morning I fire it up...

Spoke too soon, problem is back after a few good cuts.

UPnorth Sending PM.

I am running Acorn with Technic servos on my G0704. The machine is out of commision since I bought the Novakon. Really thinking about moving everything over or just selling the G0704. I think I will...

Sent PM on BOB.

Sent pm