493762
- - - Updated - - -
493764
Type: Posts; User: orbets
493762
- - - Updated - - -
493764
I did.
On the front end of the machine, there is a cover that houses the relay board (pic Location on machine), If you see evidence (or still have mice like we did) living in that area, they have...
Hi all,
Have been having an issue with the hydraulic clamps not clamping properly. The e-stop light was staying lit for about 10 seconds after clamping and then going out and I was able to...
I had the same problem. Check the above replies. A faulty reposition sensor below the table will cause the machine to stop and make it appear that it's an A/I issue. Take off the small corner pieces...
Changed the 3 AA batteries in the PHNC cabinet yesterday (machine was running) and this morning trying to start up, it looks like I've lost some parameters. PHNC is now in Chinese. Went to the...
Thanks amadajoe. I'll give that a try. Next will be the 5lb sledge hammer.
Hi all,
Been trying to get into the Parameter portion of a NC9-F Control on my FBD1030. When I press the "Internal System" button and press Parameters, nothing happens. It is not asking...
Looking to find out how to send & receive data from the control panel by using an external computer.
The machine is an Amada FBD-2512 with a NC9-F.
Any ideas?
Have narrowed the problem down to the "Shut Off Valve". We removed it to inspect and the solenoid itself appears to be intermittent and sending a signal whenever it wants. There is a small board with...
Hi,
Yes, we still have the problem but have been using in F3 & F4
Any thoughts?
Thanks.
Sorry for the lengthy explanation.
We are getting a stop alarm during the punching sequence showing "OIL PRESSURE"
The pump pressure slowly drops from 22Kgf to 15Kgf and the stop appears.
On...
OK. Found the problem today after many, many hours and lots of covers removed.
There are 2 sensors located below the table on each side of the turret that are supposed to sense the stroke of the...
The stations themselves are all ok now.
I cleared out the slugs around the A/I and tried to push down & lift up the drive pin with out any luck.
It does now look like its in the correct position....
New information.
The A/I had just finished the punching cycle and was about to move to the next tool when the error occured.
Now I'm leaning towards a mechanical problem. ie: a slug?
I need to...
ok. not the problem.
checked the A/I stations again.
While turning the turret by hand to check each A/I, it came to a hard stop.
The coupling (below bottom turret) on one of the A/I stations that...
Hi,
It is an O4PC.
The index pins do engage before it boots up.
Where should I be looking for relay SHP?
Is the switch in the PNHC panel or the Main Control panel?
Thanks
Hi,
I'm having the exact same problem today on my Vipros 357.
The inex pins are out when the machine is off.
They engage when started.
So I am assuming that the switchs actually work
I can not...