Search:

who can help me ?


how to out from this prolem ?

i have same problem with donW. i was success ton run and g100 was found , but when i run mach3, comunication lost.

anybody can help me to...

ehello

i've a problem about Ip setting.
i'm using g201 to drive stepper motor, connect to g100 as a motion control

i'm using mach3. i was set all configuration according setup guide. i was...

hello ...
can help me ?

i'm using G100

at the last time i was "launch firmware loader" with g-rex loader cause the gecko was found, but i think i was set the wrong IP address. And also i...

Thanks for your reply..

i was know that the mistake causes by wrong installation ..
so i was uninstall mach3 and g-rex loader....
then i re install the program ...

i read again all manual...

dear mariss,

i was try to the step pulse width in motor tuning but no result ...

1. in port setup, i just choose port #1 (address is 0X378)
2. in motor output i just mark x-axis, according...

hello all...
i'm indonesian
i'm trying to learn about mach3 ....

but still confusing how to setting configuration in mach3

i try to run stepper motor 2,8 A with g201 (power supply 48 V)...

hello all...
i'm indonesian
i'm trying to learn about mach3 ....

but still confusing how to setting configuration in mach3

i try to run stepper motor 2,8 A with g201 (power supply 48 V)...