Looking to upgrade my Multicam Pro Series 5' x 10' router. I really want an ATC. Has anyone had any exposure to Cam Tech? How do you think that it compares to Multicam Pro Series? Here is a link...
Type: Posts; User: Stephen Samuels
Looking to upgrade my Multicam Pro Series 5' x 10' router. I really want an ATC. Has anyone had any exposure to Cam Tech? How do you think that it compares to Multicam Pro Series? Here is a link...
Looking to upgrade my Multicam Pro Series 5' x 10' router. I really want an ATC. Has anyone had any exposure to Cam Tech? How do you think that it compares to Multicam Pro Series? Here is a link...
Hello-
I am having issues with my 'Sharp knee mill retrofit w Anilam 1100M'. When I turn the mill on it leaves (3) messages saying:
- '+x +y hard limit reached!'
- 'M4 motion board (s) + D2...
Hello-
I am having issues with my 'Sharp knee mill retrofit w Anilam 1100M'. When I turn the mill on it leaves (3) messages saying:
- '+x +y hard limit reached!'
- 'M4 motion board (s) + D2...
Hello-
I am having issues with my 'Sharp knee mill retrofit w Anilam 1100M'. When I turn the mill on it leaves (3) messages saying:
- '+x +y hard limit reached!'
- 'M4 motion board (s) + D2...
Hello Anyone-
I am in the market for a new-ish 5' x 10' Multicam router, preferably with a tool changer. I would love to find a pre-used router in good condition. Does anyone know of a place to...
Hello-
I have been having issues with my multicam kicking me out of programs/ becoming unresponsive during use. It runs thru 'Multicam DNC95'. Here are some details of what it has been doing...
In my case, it ended up being that the 'targets' were out of alignment. It seems that when homing the X-axis, the proximity sensors need to detect the targets at the same time. I had been cutting...
I am having a similar issue with my Pro Series. When the xa/ xb sensors get close to home, (1) side's proximity sensor light goes off, it slowly pushes itself into the bushings, and both the xa, and...
I have been having problems in Alphacam with using my 'drill/ tap holes' tool. When i program a drill, and try to move the part, a 'Z' axis shows up. This keeps me from being able to see the part...
I have been having problems in Alphacam with using my 'drill/ tap holes' tool. When i program a drill, and try to move the part, a 'Z' axis shows up. This keeps me from being able to see the part...