Search:

Two operations would solve all your problems. I dont see why it wont work for you I just ran that through with false numbers and with a final z set I told it depth cuts value of .05 and it generated...

Okuma wont help you cause the machine took a hit in the controller. If the machine was under power at the time the electrical damage could be insurmountable. The thinking behind this for okuma is...

RH is always your best bet. Then your spindle is running the right way, forward. The pressure on the turret is the same either way, its mounted on a rotary coupler so the force is always taken by the...

once you have told the computer (dnc source) to feed program then F2 run. In mazatrol there are tool offsets for mazatrol and for iso programs if you use the iso tool data and not the mazatrol...

Try efunda.com it is an engineering website with all kinds of specs and tolerances and formulas. All ways a good place to start to make sense of things.

That's correct but a thread is a included angle of 60 deg. So the more tpi the shallower the thread will be for example: 12 tpi .045" deep, 16 tpi is .0388" deep,
20 tpi is .027" deep, and 24 tpi...

Your clearance is always going to be different depending on pitch. your conversion is simple inch to metric conversion. 1" = 25.4 mm so 20 tpi is .05 inch per thread (1/20)
and then .05 X...

If you are trying to make these two parts fit then the thread doesn't have to standard. But if one part 40mm od and the other is 40mm id then there is no stock for threads. example if 40mm is your id...

Always roll taps in S.S. No chips no more problems and they are the strongest due to the no flute factor.

When using dnc drip the computer always waits for the control. Tool data is shared with iso programs erase one and the other is gone. You should not have to change any parameters dnc screen load...

HSS will work fine its not to abrasive just gummy. I would stay away from freezing, that will just cause more trouble. You'll think its working and then the temp will come up and you'll be at a...

Sharp tools is the key. Use tools for aluminum, large positive rake. Depending on the coolant you are using an air blast might be more efficient.

Doing a system restore might work but then you have to backup everything that you did from the date you go back to. Also any software or updates will all have to be backed up or they will be gone...

Are you cutting a t slot or just using a t slot cutter?

For a Mori simple fanuc works well.

O0001 (sample prog);
G20; (denotes inch)
G50 S2000; (max spindle speed)
G96 S300; (constant surface speed)
G0 T0101; (tool call out 01 is tool and 01 is...

If new isn't in the budget then Haas does have a used division. You will get a inspection report of the machine also a warranty. This is what i do when i need another spindle turning with out the pay...

I have used X since it came out and have never found a way to fix this. Always have auto save on it saves a lot of headaches. You can designate were you auto save to so make a folder for it and if...

The fumes from automotive coolant would be a lot to handle even with an exhaust. If you can't get metalworking fluid i suggest mineral oil. You can use it straight or with a air blast. I even have...