Well established machine shop is looking for machinist/machine operator. Experience is preferred but not required. We are WILLING TO TRAIN the right individual. We are a medium sized shop with: (9)...
Type: Posts; User: boysandjeep
Well established machine shop is looking for machinist/machine operator. Experience is preferred but not required. We are WILLING TO TRAIN the right individual. We are a medium sized shop with: (9)...
Mill Lessons Learned
So I finally got around to writing this up. I pulled out the old Dynapath 10 System and went with the Ajax All-In-One DC system. I purchased it through CNC Services North West...
cncsnw, thanks for the response.
Nice picture, I hope I dress my cables out as well. That cabinet looks just like mine, transformer, fuse locations, etc. You answered all of my questions and...
I'm ready to replace my Dynapath 10 system with an Ajax CNC. I've been reading a lot on the forums and it seems the best choice for me. I haven’t found a post that address the same situation so I...
So no luck tonight, I went through the steps and nothing. Word 9 Bit B still 0. Just for fun I tried an M06 command and the tool change light did come on briefly. I'm not sure if this is related...
I need more help, I got a lot of help on my Clausing Mill to get it out of E-stop. I'm not sure how to link to that other thread, it has some background not sure it's related but I thought I should...
I called Dynapath and based on the symptoms agreed it was probalby the encoder, a replacement is $475, a little more that I want to spend. Mines an older one with Baldor drive so it's hardwired...
So now the question is how do I fix it? I took the housing off the back of the drive and the encoder inside is a SUMTAK OPTCODER LBL-015-1000 do I try and find a replacement? Or is it fixable? The...
I called Glenn at Dynapath on Mon. and he suggested that I should try the EPROMs that I already have. I installed the E Rev and same problem. With nothing to lose, I installed the F Rev that was...
Thanks for the info, I called Dynapath Fri. afternoon, but Glenn had already gone. I will try again Mon. I pulled the boards and looked at the PROMS, On the PIC card the PIC/MILL PROM is marked...
I fixed the wiring so the e stop is hooked to the J2-14 output, 0 volts. But I think that's a moot point. I checked the Word 8 Bit B and it is 0. I actually got the Dynapath manuals with the...
Thanks for the response, it makes perfect sense but it tells me it was wired correctly and I wired it wrong. So my real problem seems to be I don't have 24 V out at J2 pin 14 (J3-1). Any ideas...
I'm new to the forum but I've been reading for awhile. I just purchased a Clausing knee mill with a Dynapath 10 controller. I have my phase converter hooked up, generated leg on the center (L2), so...