Search:

Have you looked at linuxcnc as a controller out is free a bit of a steeper learning curve then mach 3 but more powerful.

Sent from my HTC One_M8 using Tapatalk

Can you upload the image and a can have a go at it?
Edward

By changing the "Sub-Step Length" in the V-Carve settings you can control those little lines. In the first picture I used a sub step of 0.1mm and it gave the lines to the left but by increasing to...

Looks fantastic I can't wait to try it.

Hi Scorch,
There seems to be a bug with the multi pass setting in v1.47, when i set the "V-carve finish pass stock" to zero it still uses the previously entered "V-carve Max depth per pass" even...

Sorry I did not explain myself correctly, the type of letter I am looking to do is 276782
where the sides of the letter are vee'd from the edge of the letter to the center thereby producing ...

Have a look at http://www.scorchworks.com/Fengrave/fengrave_doc.html#config it shows you what to do (when all else fails read the manual :-)

If you have Cambam it can open DXF then remove duplicate points, it also has a facility called "arc fit" where it can reduce the number of points of a poly line you can also close open poly lines...

Once again a great piece of software well done, any chance of getting it to produce raised letters, I know there are work arounds but they don't do the inside corners correctly.

If your machine normally cuts correctly then I would blame the conversion of the drawing. I use Turbocad and Cambam so not sure if I can do anything for you. Can you open the drawing in a cad program...

Is it possible that the laser is focused too deep into the glass just a thought?

Sent from my HTC One X using Tapatalk 2

I do not use a cap, I have been using this setup for 1 1/2 years with no problems

Sent from my HTC One X using Tapatalk 2

Hi,
I run the exact same combination of the 4030 driver with a 425oz stepper motor. I use a 24v power supply and I wish I had a 36v supply like yours. Stepper motors can take many times the rated...

I had that problem when using baltic birch plywood for the escapement, so I now make the escapement out of segmented hardwood, 12 segments 30 deg each about 3-4mm thick I make 2 layers and glue the...

Hi scorch,
First off great piece of software. I was wondering if there is a preferred way of drawing 'shapes' in auto cad (dxf) so that all the defined paths are clockwise and is there an easy way...