Please help
Type: Posts; User: Yasser2000
Please help
Nothing to do
I change the drive
What do you mean with . Backlash
We allready find the 2 bearings of ball screw up side
Is damage. And then motor become over heat and over loud
Then we change that 2 bearings
But motor still same problem
Vibrating and not...
I try but its same problem
Please help
I change parameter 1825 . Its x motor gain loop change it from 3000 to 2000
The vipration is small down . But still same problem
The 3 coil of motor is ok by ohm
Do you think motor problem...
Grounding is ok
Wich parameter
Can you tell me please
Machine Colchester1100
Fanuc
Machine reafrance and not give any error
But the x axis after stop reafrance
Give me vipration and not stable . It try to move left and right and not stable
I...
Hi all. Need the wiring diagram for DAHLIH MCV-1020B with fanuc OM
Pdf file
Please help
Hi all. Any one have this machine
DAHLIH mcv _ 1020b fanuc control om
1999 made
I just got it and need to know if it is good or not
And need some help with it
there is 2 jumper
first one .... that one which i mark on it .... You will find it under the button
second one ..... You will find it under the first
any thing you need send me
or email me on ...
Can i use this one?
Or must be same older
Thanks
Here
B is a black button
JU is the jumper
Good luck
Hi dear
You have to catch the normal speed agine please do this ste
1 switch off the main power
2 in your spindle speed board there is 2 jumper
Remove the first one from left and fix it on right...
Yes iam still looking
I can't pm you here because it is off for my
I don't know why
But if you can help. Tell me here or
Send me Emil at
[email protected]
Tell me if your X and Y motor
Is connected to one servo drive
Or 2
Hello Mr. TechSwede
Iam waiting you
Please help
Hi Mr. TechSwede
Iam upload 2 pictures for the servo board
And for the IGBT after remove it
Please mark for me the components you want
Me to change it
Notes:
Do you mean the 5 capastores...
Thank youfor help
Iam allready upload one picture for my servo here
And as you told me
I wll change the big capastore on the servo board
And i wiil check if the alarm is gone
And if not
So i...
I checked the motor and motor wire
All is ok and if i change the servo drive with other one new
The problem is gone
So please help
Hello all friends
I got alarm 8. On my fanuc servo amplifier
And this happened in the morning
Then i switch machine power off and on again its same 8.
After 30 min
Off and on again
Its ok...