Hi
Depending on your machines design you have one or two hydraulic amplifiers (usually made by Yuken). First, you should check which is faulty. There is a fault LED on it.
After that it could have...
Type: Posts; User: norin1373
Hi
Depending on your machines design you have one or two hydraulic amplifiers (usually made by Yuken). First, you should check which is faulty. There is a fault LED on it.
After that it could have...
Hi
The clutch is hydraulic or Peneumatic?
Do you hear any noise from belts while hitting?
Did you check tool height?
Did you have any tool crashes recently? Like hitting on clamps or not putting...
Hi
If the machine can change every tool except T330, One of CNC parameters are wrong.
As you marked on the drawing, the difference is about 160 degrees. A faulty encoder behavior would mot be like...
Hello
Sent me an email
[email protected]
Good luck
Dear Mr.Franck
I had received your email notification but the email just disappeared from my phone, please resend it.
Tnx
Hi
Are the autoindex rotor shafts lock after disengagement from turret side.
Do you have any autoindex related alarms.
Suddenly a 15 degree offset is a big shift.
There is one deceleration dog...
Hi
What is 3phase wire?!
Pega 244 with 6p control is equipped with DC servos.
Hello
Which M code do you use as press pattern? Like M500 or what else
Describe the press pattern parameters which is in use
Can you see last slag in the die hole? How much is that lower...
Hi
What is your problem? Send me with details on [email protected]
Hi
Specify what do you mean by memory PCB. Bubble memory, ROM board or even PC board?
Timers and counters are not stored as diagnostic in your machine.
For parameters send email....
For any software and hardware problems contact me.
[email protected]
Brand new and ready to use motherboard is also available.
Hi
In different models of Vipros there are one or two pumps running with the same motor.
The hydraulic heat exchanger is located before oil goes back to the tank in the loop.
The heat exchanger is...
Hi
Alignment of stations usually take more time than setting up a tool. So you should use the tool align key when you are doing so.
In case you want to turn hydraulic unit off while setting up...
Hi
Your machine turret is Triple track, it means there are three tool set in a row with the same index pin. 1xx tools are inner, 2xx are center and 3xx are outer track. So they have a Y axis offset...
Hi
Did you find the password?
Hi
So late answer!
If you still having problems with your pega 244 contact me on [email protected]
Good luck
Hi
I've lost phnc parameters because of flat battery.
I would be glad if you could help.
Tnx