Check your min and max ramp length. If its larger than the pocket it will plunge instead. How long is this slot? What toolpath are you using?
Type: Posts; User: NaRbO
Check your min and max ramp length. If its larger than the pocket it will plunge instead. How long is this slot? What toolpath are you using?
RDTS
That is the exact same machine our company bought a few months ago. the washers are inside the spindle, easy to change. You will need a puller and a special tool that you can make or buy...
We recently replaced our fadal spindle. the pulley can be a pain in the ass. Took me 3 tries to finally get it to go on right. if its off the orientation to the tool changer will be out. It was so...
i finally got it working, I have cutter comp on just before it calls up the subprogram, and at the end i have the cutter going up 1" moving back to start of tool path, then back down to depth and...
I've got a fadal 88hs control for a 15xt. I'm programming a small part in the shape of an L. I've got a subprogram that repeats 20 times. I tried it with absolute mode and wouldn't come out right on...
www.fadalcnc.com
they sell new and remanufactured ballscrews. Call them up. There in the U.S, Idaho i think.
In the set parameters, it lists the spindle drive as a 3750rpm wye/delta drive. there are 2 options for 10k, one is high/low, the other is 3-step.
Hi, We have 2 fadal machines, both 1994 models, a 15xt and vmc10. The spindles i'm assuming are both 10K grease packed non-locking draw bar, also there is no high low belt adjustment, just a 1:1...