Hello
I have a Clausing Kondia that we have retrofitted with a Leadshine Ehtercat Servo system using Mach4.
I cannot for the life of me figure out how to get homing switches functional on this thing. I have pulled the homing inputs into each of the Leadshine Servo drives, mapped those inputs, but cannot get anything figured out from there.
I had originally thought Mach4 would control the homing, however it does not, Mach support has told me that the homing must be done in the motion control.
I have been through the Leadshine manual many times, however I must be a dummy cause I cannot figure it out.
The system was purchased from here:
https://www.automationtechnologiesin...h4-750w-3-axis
They have not returned phone or emails though for any support.
If anyone can point me in the proper direction I would greatly appreciate it, I’d like to get this paper weigh operational.