Application:
Specially developed for machine cleaning of machine tools with cutting oil incl. cabin, magazine, spindle, etc. Viscosity of up to 100 cSt. Without introduction of foreign medium.
The active principle is based on high temperature combined with low pressure: at up to 70 °C, greasy and oily contamination is dissolved quickly and efficiently. The low pressure is sufficient to remove the contamination without damaging parts. Thanks to various nozzles, even complex surfaces can be cleaned easily and without residues.

Advantages:
- Significant time savings of usually 80-90%.
- Reduction of expensive machine downtimes
- Cost- and time-intensive installation and removal of individual parts can be avoided
- Mobile, i.e. can be transported from place to place without any problems
- Self-sufficient: Thanks to the 60-litre tank, independent of a permanent supply of cleaning medium
- Cleaning with your own cutting oil without the introduction of foreign substances
- Higher work safety and significantly lower costs than manual cleaning with rags
- Health friendly
- No need for chemicals at all, hence significantly reduced procurement and disposal costs
- Thus resource and environment friendly

Mobile. Without dirt water collector for parts cleaning.
5m hose with lance pistol and changeable 600mm spray lance; hose attached to chassis via quick change coupling. Start-stop operation with pistol. Stepless pressure adjustment.
Cutting oil supply without pre-pressure from 60l tank, overfill control, oil shortage disconnect, overheat fuse.
Factory-set max temperature ca. 70°C, kinematic viscosity max 100 cSt/20°C.
Capacity ca. 1.1 – 2.4l/min depending upon viscosity and pressure. 6.8 KW, 16 Amp.