Vessel filter Profluid MCF 20. The Profluid vessel filter are equipped with an integrated delta P-meter. If the filter bag is dirty, this differential pressure sensor gives a signal. The filters are available in 5, 10, 25 and 50µm. If you use a duplex setup, you can change the filter bag without switching off the instrument. This facilitates maintenance. So you minimize the downtime of your machine. The result is increased productivity. Lathes, milling machines or grinding machines with an operating pressure of up to 20 bar require protection against abrasive particles such as chips and other contaminants. Especially for this application up to 20 bar we have a Profluid vessel filter in our program, which can be easily mounted on existing machines and pumps. In general, the use of filter techniques means optimum care of the cooling lubricant used. This not only extends its service life, but also that of tools and pumps. There are significantly fewer blockages of pipes and fittings. In addition, slideways and guideways are subject to less wear and tear, and by keeping the grinding wheel open, a sustained higher grinding performance is achieved. Fewer machine downtimes are another result of using filter techniques, because they remain clean and require less cleaning. They improve productivity through lower scrap rates. They also reduce operating costs. Not forgetting a significant advantage: cleaned coolants attack the skin much less. So you protect the health of your employees at the workplace.