Originally Posted by
chuck767
Configuration: windowsXP, PMDX-122 parallel port motion controller. Taig disc top mill.
Been running this configuration for years and all of a sudden it quit working.
Tried lots of things to get it running again, but can’t.
Here is something I think is unusual that may lead to the solution .
When I run the diagnostics with Mach3 and I click on the “mist toggle “, the red light on output #4 flashes on and off. See attached photo.
This should not happen since I do not have output # 4 enabled in the “output list”, see attached photo.
Any suggestions would be greatly appreciated,
Chuck 767