Search:

Thanks!
But What if want to do manual tool changes with tool setter.. don't fill the tool offset table on Mach4 and delete that H01 on the G43? Then if I want to change to another tool, Zero new...

Hi


Trying my first post files. Is there way in SolidWorks(2021) CAM to make G54 instead G54.1 P00 on g-code file?

I want to change tools manually and measure them by touch plate, but...

Hi!

I'm noob, I have not made any probe or tool height's yet. I want to find my workpiece coordinates and workpiece top height. So what I must do? On Mach4 there are these choices:

On Tool...

Hi!

I'm new to machining and CAM. What I want to to:

Make part in SolidWorks 1:1 size
Mill part 2mm smaller than its 1:1 size.
Spray part with primer, up to 3mm.
Mill part to it's 1:1 size....

Ok, thanks. How to find correct speed for those extra long mills, and chip load, feedrate?

Hi!

I am new to tooling/milling, just built my first machine. Spindle is 2.2kw 24k Rpm max, ER20 collet. What to consider(I don't want the bits to break) when milling:

MDF and XPS foam. I have...

Thanks for your suggestions!

Ok. So I have earth on AC voltage and shielding DC wires with AC earth is ok?

Hi

I use shielded wiring in my homemade router build, but I´m not sure where to connect the shielding?

On SmoothStepper I use DB25 terminals, they have usual GND pins and one marked GND?
On...

Hi, I am on my first cnc build and I need some explanation.

To calculate size of servos I use https://www.orientalmotor.com/motor-sizing/ballLeadScrew-sizing.html# , but it gives me lower Nm...

So...

Is this the right way: Servo - Nut - BK support with angular bearings - ballscrew length - bellville washers <> - BK support with angular bearings - bellville washers <> - Nut ?

And last...

Ok, I will search about bellville washers. At the moment I want this setup: x axis about 1500mm(2x) and I want to use servos 2x750w direct fit. Ballscrew diameter 20 to 25mm and stroke 5mm. Gantry...

Hi,

What do I need to know about BK/BK (both ends fixed supports) setup on ballscrew. How to calculate right distance, does one must have some offset to make right tension?