Hey guys, I've had this machine for about six years. It has run pretty good for me. Last week, the turret stopped aligning. I get a "Turret not rotating" alarm. But the turret does rotate about 5 positions before it times out. The alarm indicates a prox switch problem. I can get to the prox switch by the top solenoid and I see the one under the back cover. I don't know how to test them. I'm not sure how to get into Program ware and I wouldn't know which bit to look for. The two small springs that push the locking pin up are ok. Any help or likely remedy would be appreciated. I'm in Rochester Hills, Michigan. [email protected]