Recently the LCD monitor went blank on my 2007 haas vf2 mill. I can still run the machine by shining a flashlight on the screen to see the numbers and letters but this is a pain in the u know what....
Digital. Experienced. Powerful. - 100% Tool Management
Type: Posts; User: Lary Alvey
Recently the LCD monitor went blank on my 2007 haas vf2 mill. I can still run the machine by shining a flashlight on the screen to see the numbers and letters but this is a pain in the u know what....
I have a 1996 torq-cut 22 that will no longer turn loose of the tool holder in the spindle.
neither by the eject button or tool change command. This started several months ago
but I could get it to...
Hey guys anyone got any advice on spindle speeders. I have a contract that requires a simple PARKER HANNIFN captive O-ring configuration in 6061 alum.
I am currently cutting the groove on a HAAS VF2...
Any one know how to change the size of the toolbar icons in version 20. Just loaded my software into a new (to me) puter and I can increase the size of the fonts and general appearance but the...
Thanx jmullet it was the carousel back sensor. Had a wad of nylon chips blocking its view.......................Lary
I just finished a job on my 1996 Bridgeport torq-cut 22 everything ran fine. I tried to pull the tools from the carousel for the next job and got the message (invalid switch states) I tried to boot...
Hey guys dose any one know where to find a drawing or layout of the hydraulic collet actuator assy. for a 1989 Hitachi Seiki 3NE-300 turning center? Also looking for a seal repair kit for the same...
Hey John thanx for the advise the oil is coming out of the front right where the chuck bolts on. Any ideas where to find drawing of the machine?
Lary
Hey guys I have a Hitachi Seiki 3NE-300 Turning Center that has developed a nasty hydraulic leak around the draw bar that pulls the collet in the center of the spindle. Has any one out there ever...
Hey guys I have a 1996 bridgeport torq-cut-22 that has a broken oil feed line that supplies oil to the X axes ball screw. Its located just below the front of the table behind a sheetmetal chip guard....
I have an Hitachi seiki 3NE-300 thath aith a Fanuc 6T Dose any one know if there is a command for turret reverse at tool change. On my Ikegai a command of T0100 M12 dose the trick but that dosent...