[blade625]

Hey CNC fellows, I'm new to the forum.
We have an Excitech router with handheld pendant [DSP controller/RZNC-0501] and have been running mastercam without issue. We recently purchased Bobcad v24 to use for 3D milling [woodwork] I am having trouble getting them [bobcad] the proper information they request to build a post processor. This machine's manual didn't come with specific lists of G&M codes and their descriptions, and I haven't a clue how to find them.

Does anyone out there have a post processor for this application, or can you point me in the right direction to something already in the bobcad post list?

Thanks in advance

[Sam@Eggle]

Hello! Did you get a post processor? or have one made? I have a similar issue I have used the NC studio post with some success but it has caused some small issues. I would like to get to the bottom of this! I can get hold of the g and m code lists from china but if you have had one made already I wont bother!

[blade625]

Pm me your email address and I'll fwd the two post processors I have [mastercam and bobcad]