Search:

I too have observed this behavior. I wonder if the backlash field takes both positive and/or negative numbers. It looks like it backlash compensates in the wrong direction.

Will look over in the...

Thanks, that proved very helpful.
When I get a chance this weekend, I will post a video of my machine which has been re-wired and re-tooled to use UCCNC. While I was confused at first, its all...

Ger21,
Thanks for a point in the right direction. Looks like I need to write a macro, create a custom button where the home all button was and implement the macro. I think if i give the new button a...

Hi all!

Not sure what to call it, but i think in Mach3 it was homing backoff. In otherwords, when the machines homes, after it hits the limit switch, it would back off a configurable amount. ( I...

Thanks for all that replied, i got that issue worked out.

Another question.

I have the 5port LPT carrier board for my UC300ETH. In the manual, it says that port 3 has 2 analog outputs, from...

Thanks, that worked a treat when set to a different port. I think the default of zero was getting me on the port. No port 0! Thanks guys for the quick response.

Hi folks,
got an issue with UCCNC. Coming from Mach3 and finally getting around to setting it up. Weird problem. When I set the pin for PWM spindle, and either update or save settings, the number I...

One way of using this is: If PP/Linux could send a signal to the Arduino, it moves parts, rotates, whatever, then signals path pilot again to start the next job or repeat the same job.

For job...

use Boeshield. Developed by the boeing company to prevent rust. I (and alot of woodworkers) use it on steel and cast iron to prevent rust. Stuff works.