Calgary, AB
Type: Posts; User: getrolfed
Calgary, AB
I'd be happy to... if I could just connect with someone who sells them.
NOTE: I removed the old bearings. Only the main, lower bearing appears to be damaged. The damaged bearing is a 6006 RZ GMN (30mm shaft, 55mm housing).
I am assuming that I need to replace this...
I have a 5 HP Perske spindle from around 1995. The lower bearing is making noise and getting hot. Its time to replace it. The question is how do I source it and what should I replace it with?
Any...
I've had success importing Sketchup models into Vectric Aspire, but have had NO success being able to use those models to create an actual toolpath. I've used both the Sketchup plugin to create .STL...
I have a Routermaster 52 that came with a 5.5 HP Perske Spindle and an EMS Variable Speed drive (MODEL G3U-23P7, S/N 952004537, Model: C1MR-GJU23P7, SPEC: 23P71E)
My understanding is that the...
Hello,
I am in the process of upgrading my controller in an older CamTech RM52 machine. It is currently operational, but limited in what it can do.
It has been suggested that I upgrade to gecko...
Thanks for the input. I've been going through many threads, but must say, I am a little lost.
I'm happy to throw some money at the project....
My current power supply is : 2x 18V, 12V; 260 VA ...
Yes please! Any information would be very helpful; the repalcement parts and how it all worked out. I'm still trying to figure out what to do with this machine!
The stepper motors are
VEXTA PH296L-01
2 phase
1.7 Volt
4.7 Amp
The controller is a CamTech
RMMXZ51ABCTCMJEO
serial# 1389-9508
So, are you suggesting that the Keling 5052-48 would work on the Routermaster 52 for a 3D carving setup?
The Camtech (AXYZ) rep that I spoke with said that I could not upgrade my machine without...
Hi, I have a Routermaster 52 that I would like to "upgrade". I have been getting so many different stories about what to do from different sources including AXYZ. I just want to make sure I don't...
I have the same machine with a spare controller that I can sell you. It has all the boards in it... working!
I also have a Routermaster 52 that does work and has a spare controller box. I am considering upgrading the electronics. My understanding is that I can replace the controller with a Kelig for under...
I have a spare Camtech controller with all the cards if that of interest
I recently purchased a CamTech Routermaster 52 that is not working properly.
When I was initially looking for a CNC Router I was considering building my own - it didn't look very complicated or...