I'm not familiair with this type of machine,
but can you put a G42 in combination with a G00 within a cycle.
On some type of Okuma's it gives you a error message.
(Dit you have a error message?)
Type: Posts; User: Spaantje
I'm not familiair with this type of machine,
but can you put a G42 in combination with a G00 within a cycle.
On some type of Okuma's it gives you a error message.
(Dit you have a error message?)
There was one major problem with transmitting and receiving to a LB-xx of the early 90's:
1st : check the pins in your connector
2nd: the OSP5000 didn't have a waiting time, so you have to transmit...
Oke,
finally found a solution.
You are rigth the 5000L has only single pages for setting the parameters.
I think i do have a programmers manual with the setting for the old one.
If you still...
Brad,
do you have the special functions 2 manual of a OSP5020.
I can make you a copy of the parameter setting for RS232 comm. for the OSP5020L/OSP500L-G.
In my mind i think this is even working...
Our experience with the MA series is very positive.
Where using 3 MA40 with a U100 controller 1 MA400 with a E100 controller and a MA400 with the new P200 controller (very fast and the touchscreen...
Where using 3 MA40 and 2 MA400 all horizontal machines, they are connected to a Fastems FMS.
What would you like to know about this machines.
Hoi bradleyk,
i am also new here.
I read your question and was wondering if you change changed the wire on pin 4 to pin 9 on the Okuma side of the cable. This was a simple solution in our...