Search:

the wires were burnt because the connector was full of coolant and oil

I have a kitamura MyCenter 2 Verticle machining center with a 6M control that I was having a problem with the X axis, I was getting a 416 x servo alarm at start up but not all the time, sometimes it...

Thanks for the reply, I have servos with attached encoders so no scales and I have no Idea what the TG Alarm is and how to activate it.

Bob,

The 2ND L.S. led is always on, This is normal and is used for over travel

I too am using a rotary phase converter 20(HP) if you are going bigger I would go at least 15 or 20 hp. and the...

Kitamura Mycenter2 VMC

I get this Alarm alot when I first power the machine up, if I power up and down a couple of times it usually powers up, well not any more.

could this be a servo cable or...

where do I enter d and h offsets on a 6m I cant find an offset page

Thank you Al
where do I enter the offsets for D and H offsets?

FANUC 6M Kitamura mycenter 2 Tool change help........How the heck do I make a tool change in an actual program line (please give example) this looking at the manual it is real confusing to me.

how and where do you enter a cutter comp (D01) offset on the 6m

2nd LS For Overtravel Remove Switch should be lit at power up and is used when there has been an over travel of any axis, when you hold this switch in and use the resolver you can move off of an over...

When calling for a tool change in program what are the steps neccesary?

I know M6 T10 But I must be missing something because it just sits there.
and I know it works because I tried it in another...

Thank you CB MACH, but I have aquired pull studs. TFGC I have not seen this problem on my machine.

I am looking for the dimensions of a retention stud for a Kitamura mycenter 2 with BT 35 tool.

My email address is [email protected]

Thank You very much

Could you send me the Parameter list please

Thank you for your response to my need for Manuals for the Kitamura 6m, I can not buy actual Manuals from Kitamura for this machine they only sell a basic g-code programing manual and it cost...

Thanks for the reply, For starters if I want to move in mdi after I home all axes what are the steps involved? example: 1. selctor switch to MDI 2. G00x-2.00y-2.00f200 3. enter 4. cycle...

I just recently purchased this machine used, with no manuals and was able to get it running and zero'ed all the axes, and am not well versed on fanuc as far as basic info. for instance can some tell...