Search:

I have a 2yr old X7 servo mill and it has been quite a step learning curve to get it working well. had bad machining marks in the finished cuts due to driver tuning not sufficient for the machine....

I assumdd that posting in a "forum" with the header "help needed" would yield the desired response and information in which to build my knowledge in this area.

When my customers come to me with...

Awesome, I have no power feed on my manual mill so I have no idea what my feed rate was, on the cnc its now an issue.
My mistake posting in this forum, will leave it to the pros.

Sent from my...

Cool...did that and...wow, exact copy of page 241 in my garr catalogue :-)

Trouble is I've come from a mechanical machine and have very little clues or know how on how to use the suggested CPT and...

I just got some new garr alumastar endmills and would like to know what the best feeds and spindle speeds are on 6061-t6 alloy. Mostly side roughing. Cut depths would also be great.
My spindle speed...

I've got the X7 servo model and use bobcad-cam. Warning.....there needs to be a section of code that needs to be edited for running the drill cycles in Bobcad-cam that don't work in adtech. It will...

On my Syil X7 servo mill my z axis servo driver has stopped with an error code err-03, checked the manual for reason and the only two left are start circuit failure or circuit board failure.
I have...

I have a Syil X7 cnc mill running adtech X axis servo motor ACH11120BC and Y axis servo motor ACH11180DC both have adtech drivers QS6AA030M2.

What settings are you running for P16, P21 & P22 loop...

I have adtech drivers QS6AA030M2.
have a Syil X7 cnc mill running adtech X axis servo motor ACH11120BC and Y axis servo motor ACH11180DC both
What settings are you running for P16, P21 & P22...

:-(

.

I'm running solid edge...its great for assembles and I just drop the file out as a step file straight into bobcam and add geometry.

Sent from my GT-I9100 using Tapatalk 2

Also make sure in the machine definitions for v25 pro have the correct directions for the table travel selected..I ran into limit alarms on mine due to the table moving in the wrong direction...

I've got he x7, similar machine without enclosure or tool changer...


Sent from my iPad using Tapatalk HD

Fantastic Mike, just what I needed to know.

I'm so used to my manual mill I wasn't sure about climbing cuts, and yes I will do it as a profile next time.

Cheers

In bobcad V25, what is the best way to final finish the side of a part?

I have used the z axis finish ccw cut but get small vertical ridges in the job, should I try climbing cut?

Syil x7 servo...

Any tutorial videos for the cnc4640, just bought a syil x7 fitted with one in Australia. New from dealer.

Sent from my GT-I9100 using Tapatalk 2

Who sell slabs of 6061 T6 or higher billet 55/60mm thick?

Prefer NSW but beggars cant be choosers

Im juist starting out using bobcad and it intergrates well with solidedge st5 stp, step models. V25 mill pro.

I want to machine both sides of my stock, have set up both side origins but when I set a tool path it goes to the total depth of the stock. I set a predefined depth but the simulation again goes to...

looking for cam software for creating gcode from cad drawings on a X7 mill

just buying a Syil X7 servo linear servo cnc and I have little to no idea on what software I need to generate g-code. I am using solid edge st5 for cad drawings.

Where do I start and what will I...