Have been able to peck drill but can't get drill to retract to face of part.I used G74 z-2.5d.25k.25r.of.oo8
Can anyone help with this.
Check the parm
Set at 500
SPANNENDE TECHNIK
Have been able to peck drill but can't get drill to retract to face of part.I used G74 z-2.5d.25k.25r.of.oo8
Can anyone help with this.
Check the parm
Set at 500
hy if better control is needed, i like to write the code :
for deep holes, or when drill flute's are relatively too short, you may use the load diagram, in order to fine-tune your codeCode:G00 X0 Z2.5 G01 Z-50 F0.10 G95 Z-50+0.15 Z-55 Z-55+0.15 G00 Z50 ( or, if you wish, feed out slower, at smaller clearance G01 Z2.5 F2000 G94 ) G04 F.... ( maybe dwell a bit ? ) Z-55+1 ( back in ) G01 Z-60 F0.085 G95 ( use slower feed for the last 5mm ) Z-60+0.15 G00 Z2.5
if you wish, i may share drilling codes for osp
by the way, there is a nice okuma forum here : https://www.cnczone.com/forums/okuma/
kindly
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg