My DNM 500 ATC is releasing the tool holder before leaving it in the tool storage. Please help if anyone knows what could be the trouble source and how to fix it.
SPANNENDE TECHNIK
My DNM 500 ATC is releasing the tool holder before leaving it in the tool storage. Please help if anyone knows what could be the trouble source and how to fix it.
up
The arm might be out of alignment.
Check with 3-piece alignment tool.
There is now a DNM 500 Service manual on the post about Doosan Service manuals
http://www.cnczone.com/forums/daewoo...ml#post1807326
Doosan Service Technician
[email protected] O:973-618-2461 M:973-803-9479
Thanks for the answer, how can I check the alignement of the arm? The manual dosent have info about that,
Best regards,
I am back in the office.
Has this been resolved, or is more assistance needed.
Doosan Service Technician
[email protected] O:973-618-2461 M:973-803-9479
Do you have the alignment tool?
Doosan Service Technician
[email protected] O:973-618-2461 M:973-803-9479
I dont have that tool.
This tool is required to check/correct alignment (in whatever size taper that your machine is)
They are somewhat expensive.
Your local dealer might have one, or have access to one.
You could contact them about coming-in to align the tool changer.
Your Local support in Chile is:
VMV Maquinaria (Chile)
Eduardo Matte 1910 Santiago, Chile
562 555 0588
Doosan Service Technician
[email protected] O:973-618-2461 M:973-803-9479
Thanks, I appreciate your help.