The FME17 face milling system from ZCC Cutting Tools Europe has been specially developed for the demanding tasks of roughing and finishing flat surfaces with high demands on surface quality and contours and is currently available in the diameter range 50 – 400 mm. The 75° milling system in combination with 8-flute negative inserts produces increased cutting edge stability. New chipbreakers for roughing, finishing and general machining also provide positive cutting geometry and thus lower cutting pressure, while the open chipformer design ensures controlled chip evacuation. The SN*X plates in the new design, available in four grades for use on steel, stainless steel, cast iron and high-temperature resistant materials, are characterized by increased fracture stability and thus increased process reliability. Finally, a detail on the subject of cost-effectiveness and reduction of variants: The SNMX120512-* plates can also be used on two other ZCC Cutting Tools Europe milling systems, FMA17 and FMP17.

&Uml;ber überzeugen konnte das Frässystem inzwischen bereits bei Anwendungen in der Automobilindustrie: Unter Randbedingungen mit ungünstigen Spannsituationen, lange Auskraglänge des Frässystems sowie Vibrationen und schlechten Oberflächen mit resultierten Standzeiteinbrüchen konnte das FME17 Frässystem bei der Zerspanung von GGG50 mit 30% mehr Zeitspanvolumen glänzen. Translated with DeepL