Search:

The belt is geared. it should never slip.
The motor is not very powerful though.
Just how hard are you cutting?
I can only tap up to 3/8 in steel.
Any bigger tap the motor slows down/stops.
Just...

Does it DNC?
Where is the WHOLE THREAD describing this topic?
If there is none WHY NOT?
Thanks,
Steve

Hi Dan,
I am looking for the diode callout on my spindle drive board on my old fanuc 10t.
could you send me this schematic. I cant quite read the chart.
Do you know the diode type? is it just...

I am replacing a small simple diode on my fanuc 10t spindle velocity control unit.
I cannot find an identifier on it other than the regular diode sign on the board.
It is small glass and one blue...

The fee is 2500 per year for all machines owned by the company.
If you buy a new makino you get unlimited phone support for all machines lifetime.
I havent gotten it yet.
I only own 1 right now...

I found my answer!!!

There is a switch as suggested.
Thank you for that wise info.
Leadwell service directed me to it.
It is right there but there is a blank page on top of it.
The arrow down...

96 leadwell v30
fanuc 18m
looks like version BDBI 0025
Basic + option -A1

Been in the param/ offset-settings all night.
I cant find a way with just online search.
Looking for anyone who...

I cannot dnc because this fanuc 18M doesnt have a tape mode.
How can I do DNC?

Am I missing something?

I have no manual but have searched and found connection parameters,
but I need to put it...

I work on these machines pretty often but I can't find any info like:
How hydraulic turret is controlled, mechanics etc.
I have pulled it apart once -last year.
I think it may be in the manifold-...

Hi,
I use surrf99 and have a cnc lathe fanuc though.

g99 is for feed per rev versus
g98 feed per minute.

That is the simple question.

The other about the post processor...
the lathe post...

The machine will tell you if it thinks no wire is connected.
It will do it by that alarm rs232 not ready.
The computer will not say there is no plug, but the machine will.
You are able to get on...

Looking for cheap, easy, GOOD Wireless DNC.

Any experiences to share out there?

I finally found a cure. I ran the NCnet dnc software which has block size control. I set the block size to only 10 characters.
I have fanuc Om which always ran fine but my fanuc 10m had very...