[Timo_R]

Good evening Gentlemen,



I would like to receive Data from the incoming channel IN1.

For this purpose, I would like to manipulate the regular DLL-files

of the official open-source program of MACH3.

In addition, I would like to write my own c-code for receive DATA

from IN1.

For this purpose:

I need the addresses from the relevant DLL-file, at least I must open

the DLL-files first.

Is it a must to enable the IN1 or the controller board before I can

grab the Data per "bulk transfer"?

Now is the status of my controller board: the red light is flushing.


Is there any fundamental support for doing this?



Best regards