My company has purchased this machine from China, that has very little support or training material. I am looking for any assistance getting it up and running. The machine was pre-programed with the pieces that are to be made but when the programs where run, the machine axis crashed into each other, breaking some parts of the machine. I have been able to reprogram one piece and make it successfully but it took many, many, many hours to figure it out. I am looking for someone to mentor, training info, design software, anything. I am at my wits end with this thing. I am located in South Central Virginia about 35 miles north of Greensboro, NC. PLEASE HELP ME! This thing is about to push me over the edge.