Are servos or stepper motors installed at this time? Brush servos can be driven by the Gecko G320 drives, while steppers require a different type of drive.
Results 1 to 5 of 5
Threaded View
-
06-11-2024, 09:27 AM #5
Member
- Join Date
- Jun 2024
- Posts
- 6
Re: Just bought a Plasmacam with no software - best options?
Reply With QuoteSimilar Threads
-
I bought an older plasmacam setup and am having a connection problem
By setlab in forum PlasmaCamReplies: 4Last Post: 03-20-2024, 11:49 PM -
$15k for PlasmaCAM? Any other options for Israel?
By activefarming in forum Waterjet General TopicsReplies: 9Last Post: 01-20-2016, 11:43 PM -
Plasmacam will not allow upgrade to DHC2, need options.
By SSMrob in forum PlasmaCamReplies: 4Last Post: 01-03-2014, 06:52 PM -
What are my options? Just bought an X3 from harbor freight.
By bassmanss in forum Benchtop MachinesReplies: 14Last Post: 02-01-2010, 02:06 PM -
I just bought an ESAB PCM 150 for $750. Torch options?
By semi-lucid in forum Waterjet General TopicsReplies: 6Last Post: 03-04-2009, 12:50 AM
Tags for this Thread
Posting Permissions
