Good afternoon fellow CNCers
I have a older Zenbot 24x24 that has been thru MANY projects, mostly using Cut2D and Mach3 software.
However... over the winter the old PC that I had been using with it decided to die..... and that puts me at
a bit of crux. The former PC had a db25 parallel port and the new machine I want to use does not.....
So how do I get around this issue? I have seen posts about uc100 connectors???? But where
does one find those???? I have seen a lot of posts about fakes that don't work etc.
If anyone could help me out, I sure would appreciate it! It is a oldy but good machine that I would
love to get working again.....
Cujo